Call Darin at smart center Portland. He has them. I installed one on my smart about 2 weeks ago. One note though, they fit TIGHT. I actually had to trim about 1/8" off the top of the seal in order to get my air cleaner lid to close. Then it was fine. Darin told me that if you have a little more patience, it will go in without modification. Biggest issue is that the molded rubber K&N uses is much stiffer than the OE foam seal. I did notice a difference in my mileage. I had been averaging 43-44 using A/C about 40% of the time, now I am getting the same using A/C 100% of the time. Can't wait to see what I get when it cools down a little and I don't have to use A/C. Next mod DTH exhaust. But I'll wait until spring for that.