Great that is exactly what I need and for what I'm planing will work just fine.
OK I will be putting in a CarPC that I have in to the car. I need the measurements to determine a monitor size that would be in place of the two interments with virtual digital insterments display in the monitor. The PC is will drive two monitors one in the dash in place of the stereo location and the other I'm hoping to get an actual high res VGA touchscreen that will fit instead of the standard 7" video displays where the two instruments would be. I don't want to put too big of a monitor that would obstruct the windshild.
With behind the seats ,the PC is already done. Just needed to know if the mobile case and stereo amplifiers I have it in will actualy fit behind the seats or in that rear tailgate. The PC does full GPS, Stereo, DVD, WiFi and cellular networking, night backup camera and ECU diagnostics.
As far as the floor board I just trying to find out If I have to pull up material that is glued down and clean glue becaue I am going to Dynamat the entire interior and I need to get down to bare body/floor board to attach the Dynamat material. Then I will cover back up with what ever is used rubber, carpet etc.....
I'm hoping to do most of this stuff "Stelth" with out having to go to too much modification as like the Yellow Al&Ed's Stereo car here.
The car is going to be sponsored theme car. I also need to find someone who can take a high res photo and make a wrap for me.
Today
Linear Mode
