Help to paint panel

[Kermit]

I thought we were just talking about the lower black panels.

For the regular panels, that info is easily found on Evilution's site.

To get the front black air dam off I would recommend pulling the entire front of the car off as it is MUCH easier to get to as there are pins holding it together and some of the places are near impossible to get in. The back skirt isn't too hard to remove, just pull the screws & pins and then it unsnaps.

[Henrisc300]

Thanks you all for your help. I will start painting this weekend...

[Turbo42]

Originally Posted by Dunerunner

BB, More points if you can tell us what spray equipment you are using! Gun type, tip size, HVLP, cup, pot? Compressor or Turbine?



BTW - Posted up your painting instructions to http://www.smartcarofamerica.com/for...-should-14377/

I use a sata rp and a devilbiss cvi
tip for sata 1.3 clear coat gun
tip for cvi 1.4 basecoat gun
both guns are conventional not hvlp but thats up to the painter I prefer non hvlp
They are standard cups that come with the guns
and a 60 gallon compressor or a 33 gallon