Smart Car Forums - Reply to Topic
Thread: torque specs Reply to Thread
Title:
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now



In order to be able to post messages on the Smart Car Forums forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in










  Additional Options
Miscellaneous Options

  Topic Review (Newest First)
06-26-2019 10:01 AM
1983JZR3W That is a very good description, but "Dunerunner" was banned from the forum more than 5 years ago and won't have the chance to read it.
06-26-2019 08:36 AM
rocketjon Dunerunner, the units of torque are ft lb, nm , ..., not ft/lb or n/m. Torque is the product of force and distance with the force applied perpendicular to the direction that the distance is measured. That's important when you are pulling on a wrench or breaker bar, that is a foot long, with a force of ten pounds in order to produce 10 ft lb torque. If you are not pulling perpendicular to the bar you will generate less than 10 ft lb. I'm not trying to be a wise guy but I think we should use the correct units and be consistent. It is very common, and very wrong, to say, for example, "30 pounds tire pressure" (should be 30 pounds per square inch, ie. lb/in^^2, or PSI), or "1500 BTU heater" when it really is BTU per minute (BTU/min). Off course the worst (and most dangerous) thing is to mix up metric and English units. Nasa did this on a Mars mission several years ago and destroyed an expensive spacecraft when they mixed up the units for a thruster firing to slow it down. Turns out one group of engineers was using pounds and another was using Newtons.
03-01-2009 06:17 AM
Periclaws Thank you for the help. I read thru posts and cube states 8nm .tire rack told me 4nm which translates to 35.4 inch pounds.I did not mount the tires yet.but good news I found a cheap source of tpm sensors. It was confirmed by Tire Rack but since I have yet to mount them can't personally confirm it.
oh the source is cheaper than tirerack.
02-26-2009 10:55 AM
SylenThunder I found this on the Hanco site...

  • On vehicles with tire pressure sensors within the wheel, sensor nut and valve cores must be torqued to specified inch pounds.
Cores must be at 0.13 - 0.27 ft. lbs. (0.17-0.37 N.m).

Found other sites that specified 1/4" Inch Pound for the correct torque
02-26-2009 09:03 AM
Dunerunner Torque Specifications:

Lug/Wheel nuts - (24mm hex)
81 ft/lbs
Oil Filter - 14Nm (10.3 ft/lbs)
Oil Sump nut (Drain Plug) - 65Nm (48 ft-lb)

Don't have anything for TPMS but I believe it was in one of the wheel swap threads somewhere.
02-25-2009 05:09 PM
Periclaws
torque specs

Anyone know the torque specs for the tpm sensors? And while I am at it the wheels?

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

 
For the best viewing experience please update your browser to Google Chrome
 

Clubs, Garage Plus vBulletin Plugins by Drive Thru Online, Inc.