Smart Car of America Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. 451
    Hello! My 2008 Passion is starting to vibrate due to the old, original engine mounts being worn down. I had the lower mount changed out recently, and learned after that all mounts should have been changed at the same time. I’d like to try to change the upper mounts myself. I have the parts and...
  2. 451
    Hello, When I purchased my smart, I went through and replaced a ton of things. Including all 3 of the engine/motor mounts. I got the lower one from @SmartMadness and the top 2 from a different online supplier (OEM) and installed them following the article on Evilution website. So they were...
  3. New Members Area
    Hello all Need engine mount can't decide between OEM or BMS. Read a lot that is too hard and can transmit too excessive vibration to body Anyone with any experience please advise
  4. smart General Discussion
    Well, I'm coming up on my 50,000 mile service. I hate to say it, but my smart is typical. I say this because: I had the bad wiring problem where it would burn out headlights. On the third one in 2 years I took it to the dealer and they found the loose wire. Some time before the 30,000...
  5. smart Operation and Maintenance
    So I took my 2009 smart to the dealer for it's 40K service, which is $560 BTW. I got a call from the dealer telling me they discovered some problems. First problem was the rear axle seal was leaking. $440 to fix that. Next is a collapsed motor mount. $170 to fix that. I am shocked! The...
1-5 of 5 Results