Smart Car of America Forum banner
1 - 1 of 1 Posts

291 Posts
Discussion Starter · #1 ·

I was looking for a way to mount another gauge and came across this 3D printed part.

I was originally going to fit an 'digital (7/8" thick)' gauge where the clock is.
Digital for thinness and not having to plumb vac lines say for the boost controller.
But I like that clock :) and decided to try out this gauge pod.

The vent pod on the left side is obstructed by the steering wheel so it had to go on the right side.
This seller also lists some $60 fee in his auctions so I believe the same part could be made for 451s and 453s.

I may go with a digital 'OBD2' gauge in another 450 where I didn't double the boost...
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.