Smart Car of America Forum banner
1 - 1 of 1 Posts

· Registered
22 Posts
Discussion Starter · #1 ·
I run Torque PRo on an android tablet and after a battery issue and the three vertical hash-marks on the dash for about 10 minutes , I decided I would run the scan function for error codes and came up with two

P0901 Clutch actuator -circuit range/performance according to Smart Evilution website

P1800 - which I cannot find much on but the notes said Clutch actuator as well

The car shifts fine, however I always use the paddle shifters or the manual model on the stick.

Could this be caused by the actuator sticking due to a lubrication issue ?

Thanks in advance for any help.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.