Have a 2008 Fortwo convertible it’s having problems closing. It’s hanging up on the door rails. I have already replaced all the sliders still hanging up. And When it rains top leaks I assume it has to do with the seals. I can’t find a place to order replacement rails. Any suggestions?
Convertible part
Join the discussion
Recommended Reading
-
another expensive muffler
smart Operation and MaintenanceThis is my second exhaust system in 21 months. The muffler is fine. The weal spot is the flex pipe that connects to the muffler but it's all a single unit. The part itself is $380, plus tax, installation not included! Anyone have cheaper alternatives? Anyone else have this problem of frequent...- 21
- 748
-
vealham · updated
-
451 Electrical Issue(s)
smart Operation and MaintenanceMy 2008Passion Cabrio has unique electrical issues, and without an electrical schematic, I cannot troubleshoot them. On the off-chance that someone also experienced these, here goes: 1. My alarm system will trigger occasionally for no reason. If this happens out of earshot, it kills the battery...- 5
- 166
-
Smartcar 2012 not shifting into reverse or 1st gear
smart Operation and MaintenanceHello, I am new to the forum but I was looking to get some ideas on what might be happening with my 2012 smart for two passion. I bought it second hand and have had it for about a year. It has 68,000 miles on it and has been quite a pain with repairs recently. I had to replace the control module...- 2
- 120
-
IAT sensor and wire colors
smart Operation and MaintenanceWhere is the IAT sensor located and is there an easy way to tap into the wires? I just recieved a gadget that taps into the IAT sensor and the O2 sensor that is supposed to increase power and gas mileage.2008 Cabrio.- 13
- 6K
-
chumly · updated
-
Stretch belt removal and replacement 2011 Smart Found an easy way using a hydraulic jack
smart Operation and MaintenanceThe stretch belt tools do not fit the crankshaft back of pulley with no clearance so I used the AC compressor pulley. The problem is though (and in another thread I read the person managed by finally using a screwdriver in front of the stretch belt tool creating pressure for friction) there is...- 0
- 98
Join now to ask and comment!