Smart Car of America Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
861 Posts
Discussion Starter #1
where would the dome light plug/connector be located?

i read all 6 pages of dome light plug and did not find an answer
 

·
Super Moderator
Joined
·
11,309 Posts
All 6 pages of what?? I would assume you would need the wiring diagram from MB to show the location on the car for the plug.
 

·
Super Moderator
Joined
·
11,309 Posts
According to the Evilution site, the interior dome light has a connector right at the light. looks like you pry it down from the switch side and the wires plug in on the opposite side. Looks like 3 wires, power, ground to doors, and ground to switch.
 

·
Registered
Joined
·
1,938 Posts
Be aware this is a CANBUS system, if you cut or modify a wire and it serves multiple systems the car may not start.
 

·
Super Moderator
Joined
·
11,309 Posts
Canbus communication is usually between devices like computers, or devices that generate some sort of feedback. I doubt it would be used for a light bulb.
 
1 - 7 of 7 Posts
Top