Smart Car of America Forum banner

Problem with rear lights... any suggestions?

11673 Views 7 Replies 8 Participants Last post by  mloganusda
Recently our drivers side brake light went out on our 2008 SmartCar. When removing the bulb I actually broke the bad bulb and then had a hard time getting the new bulb in.

Now both brake lights work. Both turn signals work BUT the problem is, at night when the headlights are on and the rear lights are on, the drivers side rear light doesn't work it works when braking and as a turn signal. It does not come on like the passengers side does. So now at night when driving down the roads with the headlights on, the back passenger light is on but the drivers light is not.

Has anyone experienced this?

Does anyone know if I can fix it or what I would need to order to fix it?

Is it possible part of the bulb isn't making the connection to light up at this time because when removing the bad bulb one of the prongs/things the bottom of the bulb touches somehow was bent and now is not touching?

All suggestions, insight, etc are extremely appreciated. I don't want my wife to get pulled over.


Thanks!
1 - 1 of 8 Posts
Sounds like a bad ground. When it goes bad, it grounds back through the bulb on the other side. Check the ground connections on both sides, and of course the wiring and bulbs on both sides. Also check any trailer wiring or accessories wired into the circuit as well as the fuses (mentioned earlier)
1 - 1 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top