Smart Car of America Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
41 Posts
Discussion Starter · #1 ·
I had a fender bender due to the lack of rear view mirror view. Have since added a small convex to correct that. But back to my problem, replaced driver door frame and panel. Now that I have it back together I have nothing supporting panel near latch. It will settle down. There is a piece I had left over and can't remember where it came from. Has an adjusting type screw in it. Can see what looks on panel like it is supposed to be supported there. Anyone of you had door panel off that can help? It is a 2016 453
 

·
Registered
Joined
·
41 Posts
Discussion Starter · #3 ·
Looks like that #2 item. But not showing that adjusting screw in it. I was just out there and panel not connected good at window. Too hot now to mess with.
 

·
Registered
Joined
·
3,297 Posts
That is a 453, more specifically 453.353. depending on model year the xxx will vary as in 453.xxx.

Sent from my moto g(7) power using Tapatalk
 
1 - 6 of 6 Posts
Top