Smart Car of America Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
33 Posts
Discussion Starter · #1 ·
I recently bought a smart and I plan on vinyl wrapping the car very soon, but the panels, especially the back bumper have a lot of deep scratches on them which will obviously show up on the wrap which i want to avoid.

has anyone had any experience sanding down and using body filler on these panels? i assume they're plastic so they're going to react different than a normal car panel would.

any recommendations on grit number? not tryna spend $1000 on new panels.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top