Smart Car of America Forum banner

Status
Not open for further replies.
1 - 13 of 13 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1 (Edited)
Set of four original alloy Brabus wheels from an '09 Smart4two 451

$400 for all four! (cost about $2300 new) Wanted to keep them but need the space in the garage!

One owner
Garaged and low mileage with about 25k miles

Two each of front (15 x 5.5) and larger rear (17 x7.5)

The rear wheels need straightening and one needs minor refinishing - but still look better than most used wheels we have seen!

Pick up in local area of Anne Arundel County, Maryland or we can plan to take a drive and meet you somewhere else.

Stored in boxes but not strong enough for mailing.

Brabus wheel center covers are available for $20 each & shipping. Can mail the covers.
 

Attachments

·
Premium Member
Joined
·
7,596 Posts
Set of four original alloy Brabus wheels from an '09 Smart4two 451

$400 for all four! (cost about $2300 new) Wanted to keep them but need the space in the garage!
Folks although this tire combination is becoming hard to get - this is an absolute BARGAIN for the 451 B'bus wheels!!!

You snooze, you loose . . .
 

·
Premium Member
Joined
·
7,596 Posts
What does it cost to "straighten" a wheel??
Repair cost of a wheel dent is actually reasonable if the shop has the proper equipment.

Google local offerings or call a collision center and ask who they might suggest?

B’bus wheels are soft and if you are a DIY person grab a 2x4 and check out the You Tube videos...
 

·
Registered
Joined
·
563 Posts
I had 2 Trans-am GTA wheels straightened out in the Allentown PA area and at that time they charged me $75 per wheel . (That was the 90’s ) they had a special machine that could do this and correct most runout issues too .
 

·
Registered
Joined
·
6,886 Posts
I just had a alloy wheel straighten, refinished, clear coated. Pot hole damage. Cost me $150.00, for the one wheel. Looks brand new.
 

·
Registered
Joined
·
3 Posts
Discussion Starter #13
These Brabus wheels are sold! But if anyone needs to repair these wheels - look for a place that has a CNC (COMPUTER NUMERICAL CONTROL) machine!!
 
1 - 13 of 13 Posts
Status
Not open for further replies.
Top