SFR Turbo install question.

1804 Views 8 Replies 3 Participants Last post by RLYSMRT, Mar 4, 2020

RLYSMRT

Discussion Starter · Feb 24, 2020

I will be purchasing a kit from SFR with all the options possible, (Go all the way or nothing). My only concern is with the install of the oil cooling lines. The feed and return. Will I be drilling into the oil pan for the return? If so, I'll need a new oil pan gasket correct? I'm hoping there are ports that are on the engine already. Seeing how in Europe it came stock with a turbo. Any help would be greatly appreciated. Thank you.

P.S. I will be doing a 1/4 run a few times before and after the stage 2 install.

Save

1 - 1 of 9 Posts

jetfuel

· #6 · Mar 4, 2020

...you really don't need a new pan...just get a banjo fitting that will install where the oil pan drain is at....and don't let people tell you " is a bad idea "... mine has used that's setup for ten years...as well as the other two BMS turbos...

Jetfuel....need pics?

Save

Reactions: 1

1 - 1 of 9 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month