Smart Car of America Forum banner

1 - 1 of 1 Posts

·
King of Smart Gadgetry
Joined
·
1,084 Posts
Discussion Starter #1
I connected my ODBII port on my 451 and went into data stream mode so that it would do pretty much what the scan gauge does. I noticed that with my foot flat on the floor for acceleration it told me that my throttle position was at 88%. I was thinking it should be 100%. Is there anyway to remedy this? I tried the key on throttle to floor then turn key off, then wait a minute before turning back on the ignition. That tip was posted on another thread a couple of weeks ago. It didn't help my situation. It's not a critical thing but would like it to be 100% open at full pedal. I would guess to recalibrate it would take the star computer? DCO
 
1 - 1 of 1 Posts
Top