Smart Car of America Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
57 Posts
Are you going to JB Weld the thing back in, or tap it out and insert a "banjo" bolt?
I was leaning toward replacing the entire cover. I've never done that before and seems like it is rather involved. I don't think I could trust JB Weld on it. Would question whether tapping and using a banjo bolt would affect the pressure in a negative way?
 

·
Registered
Joined
·
57 Posts
I can find a M20 tap but what about the bolt. Seems like I need just a M20 pipe nipple, right? A quick search shows them all to have a large added hex nut on them that would be in the way.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top